+33175432870
info@draytek.fr
12 rue des Chauffours
95000 Cery
Google map
Article sections
This article demonstrates how to set up Vigor Router as a VPN server for IKEv2 VPN and how to start the VPN from an iOS device.
1. Go to VPN and Remote Access >> IPsec General Setup, input a Pre-Shared Key, then click OK.
2. Go to VPN and Remote Access >> Remote Dial-in User, click an available index number to edit the profile.
- Check Enable this account
- Check IPsec Tunnel at Allowed Dial-In Type
- Click OK to save
Now the settings are complete. If the VPN user is online, you will see VPN connection status at VPN and Remote Access >> Connection Management.
Connecting VPN from iOS
1. Go to Settings >> General >> VPN and tap Add VPN Configuration
2. Edit the configuration as follows:
- Select “IKEv2” for Type
- Type the WAN IP or hostname of the router at Server and Remote ID
- Select “None” for User Authentication
- Disable Use Certificate
- Type the Pre-shared key in the router’s IPsec General Setup at Secret
- Tap Done
3. Switch on Status to start the IKEv2 VPN connection to Vigor Router.
1. Go to VPN and Remote Access >> IPsec General Setup. Type Pre-Shared Key then click Apply to save.
2. Add an IPsec VPN profile at VPN and Remote Access >> VPN Profiles:
- Enter Profile name
- Check Enable
- Select “Enable” for For Remote Dial-in User
- Specify the LAN network for VPN client at Local IP/Subnet Mask
- Select “IKEv2” for IKE Protocol
- Click Apply
Now the settings is complete. If the VPN user is online, you will see VPN connection status at VPN and Remote Access >> Connection Management.
Connecting VPN from iOS
1. Go to Settings >> General >> VPN and tap Add VPN Configuration
2. Edit the configuration as follows:
- Select “IKEv2” for Type
- Type the WAN IP or hostname of the router at Server and Remote ID
- Select “None” for User Authentication
- Disable Use Certificate
- Type the Pre-shared key in the router’s IPsec General Setup at Secret
- Tap Done
3. Switch on Status to start the IKEv2 VPN connection to Vigor Router.